▧EleksLaser Extra Moduel


Firmware Instruction


First , Click here to download the EleksRom_Pro_2.2

Unzip the EleksRom_Pro_2.2.zip

Connect your EleksLaser A3 to compurter then Click EleksRom_Pro.exe


If your MansSE are using EleksRom V3.7

First , after open EleksRom_Pro.exe , please choose your machine serial port.

Then choose firmware to Grbl_v1.1 , and click Flash , waitting for it finished


If your MansSE are using GRBL 1.1

First , after open EleksRom_Pro.exe , please choose your machine serial port.

Then choose firmware to Settings_Clear , and click Flash , waitting for it finished and hold on for about 10 second.

You dont need plug out your ManaSe , and then choose firmware to Grbl_v1.1 , Flash again and waitting for it finished.


Assembly & Connection

Our recommand limit switchs install location is one the machine TOP RIGHT

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_extramodule_19.jpg

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_extramodule_10.jpg

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_extramodule_11.jpg

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_extramodule_12.jpg

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_extramodule_13.jpg

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_extramodule_14.jpg

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_extramodule_15.jpg.

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_extramodule_16.jpg

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_extramodule_17.jpg


Software Instruction


Now , you can open your Control software , like EleksCAM/T2 Laser/Candel

If you are not following our recommand limit switchs install direction. you need change your Setting like this :


When first time you install switch or trigger switch when moving axis , your controller board will become into LOCK mode

you need type Gcode $x to unlock machin like this.

then use Gcode $H to start Homing cycle.


Here are the advanced settings


  • Show pagesource