Table of Contents
▧EleksLaser A3 Pro
Assembly & Connection
Operating Instructions
1.Connect the usb cable and power supply firstly.
2.Open the EleksCAM Software.
3.Click the button on the right-top of EleksCAM and then click install driver.(only need install once)
4.Close EleksCAM.
5.Open Device Manager to find the serial port number.
6.Open Elekscam and then choose the right serial port number.
7.EleksCAM will show connect success (Find Serial Ports Successful COMx).
8.Click Select Machine and then choose EleksLaser , and messagebox will
show “Switch To EleksLaser Mode Successful” if operation Successful.
9.Turn on the controller board power button.
10.Turn on the weak light button.
11.Place the material , and then keep rotate the nuts until get the minimun point.
12.Set step movement to 10 , manually click arrow to move machine into your idea position , and then click Set Home
13.Turn off the weak light button.
14.Click Gallery to choose the picture , double click the target picture , modify the Acreage/Speed/Mode , and then click generate. (if there is an error , please ignore)
15.Click Start to Carving.
Engraving completed
