EleksDraw Pro

Assembly & Connection


Operating Instructions

DownLoad EleksCAM v3.1

1.Connect the usb cable and power supply first.

2.Click the button on the right-top of EleksCAM and then click install driver.(only need install once)

3.Close EleksCAM.

4.Open Device Manager to find the serial port number.

5.Open Elekscam and then choose the right serial port number.

6.EleksCAM will show connect success (Find Serial Ports Successful COMx).

8.Click Select Machine and then choose EleksDraw , and messagebox will showed “Switch To EleksDraw Mode Successful” if operation Successful.

9.Turn on the controller board power switch.

10.Clip the Pen and put down paper , Set Servo angle 20 degree, click [Laser ON]/[Laser Off] and tune position of pen as shown.

11.Check[X-REV] and [Y-REV],Set step movement to 10mm , manually click arrow to move machine to central point , and then click Set Home.

12.Click Gallery to choose the picture , double click the target picture , modify the Acreage/Speed/Mode (Suggest to choose Outline) , and then click generate. (if there is an error , please ignore)

13.Click Start to drawing.

Frequently Asked Questions

  • Show pagesource