Table of Contents

EleksMana

EleksMana Can support EleksMill丨 EleksLaser丨EleksDraw丨EleksEgg


eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_eleksmana_mana.jpg

  1. “Servo” is port for servo motor, “Laser” is port for 3 pin laser, “Motor” is port of 12V, can be connected with 2 pin laser or others.
  2. Please do not connect the power supply above 12V, outside is negative and inside is positive, it is recommended to use 5A or higher power supply!
  3. Please connect usb cable firstly, then open software, connected successfully then turn on power switch.
  4. If you feel the motor torque is small, please adjust the potentiometer on the motor driver, don't make it too high, otherwie the motor will be hot!
  • Show pagesource