Differences

This shows you the differences between two versions of the page.

Link to this comparison view

eleksivaxisold [2018/09/28 12:45] (current)
eleksmaker created
Line 1: Line 1:
 +======EleksIVAxis Instructions======
 +EleksIVAxis Can support EleksMill丨 EleksLaser
 +
 +---
 +
 +{{http://​eleksmakeross.oss-ap-southeast-1.aliyuncs.com/​wiki/​EleksIVAxis/​IVAxis.jpg}}
 +
 +1.This control board can only be used with CNCUSB software, need to register firstly,​please contact the seller for registration.
 +
 +2.Please do not connect the power supply above 12V, outside is negative and inside is positive, it is recommended to use 5A or higher power supply!
 +
 +3.If you feel the motor torque is small, please adjust the potentiometer on the motor driver, don't make it too high, otherwie the motor will be hot!
  
  • Show page