Table of Contents

EleksIVAxis Instructions

EleksIVAxis Can support EleksMill丨 EleksLaser


eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_eleksivaxis_ivaxis.jpg

1.This control board can only be used with CNCUSB software, need to register firstly,please contact the seller for registration.

2.Please do not connect the power supply above 12V, outside is negative and inside is positive, it is recommended to use 5A or higher power supply!

3.If you feel the motor torque is small, please adjust the potentiometer on the motor driver, don't make it too high, otherwie the motor will be hot!

  • Show pagesource