Draw Module For EleksLaser



Assembly & Connection

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_drawmodule_01.jpg


eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_drawmodule_02.jpg


eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_drawmodule_03.jpg


eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_drawmodule_04.jpg


eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_drawmodule_05.jpg



Operating Instructions

DownLoad EleksCAM v3.1

eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_eleksdraw_new_40.jpg eleksmakeross.oss-ap-southeast-1.aliyuncs.com_wiki_eleksmanase_mana-se.jpg elekswiki.oss-ap-southeast-1.aliyuncs.com_eleksmanase_sev3.1.jpg


  1. “Servo” is port for servo motor, “Laser” is port for 3 pin laser, “Motor” is port of 12V, can be connected with 2 pin laser or others.
  2. Please do not connect the power supply above 12V, outside is negative and inside is positive, it is recommended to use 5A or higher power supply!
  3. Please connect usb cable firstly, then open software, connected successfully then turn on power switch.
  4. If you feel the motor torque is small, please adjust the potentiometer on the motor driver, don't make it too high, otherwie the motor will be hot!

1.Connect the usb cable and power supply first.

2.Click the button on the right-top of EleksCAM and then click install driver.(only need install once)

3.Close EleksCAM.

4.Open Device Manager to find the serial port number.

5.Open Elekscam and then choose the right serial port number.

6.EleksCAM will show connect success (Find Serial Ports Successful COMx).

8.Click Select Machine and then choose EleksDraw , and messagebox will showed “Switch To EleksDraw Mode Successful” if operation Successful.

9.Turn on the controller board power switch.

10.Clip the Pen and put down paper , Set Servo angle 20 degree, click [Laser ON]/[Laser Off] and tune position of pen as shown.

11.Check[X-REV] and [Y-REV],Set step movement to 10mm , manually click arrow to move machine to central point , and then click Set Home.

12.Click Gallery to choose the picture , double click the target picture , modify the Acreage/Speed/Mode (Suggest to choose Outline) , and then click generate. (if there is an error , please ignore)

13.Click Start to drawing.

  • Show pagesource